MultiCam Installation Instructions ---------------------------------- 1. Switch on your computer and start Windows. 2. Log in with administrative rights. 3. If a Euresys board was newly added in the system, the "Found New Hardware Wizard" will detect the board and possibly prompt for user action. Don't pay attention to this wizard. 4. Run "MultiCam_6_0_0_1.exe" or "setup.exe" directly from the CD-ROM or the source media(*). 5. Select the option (setup type, destination directory, customization...) to install MultiCam. 6. Depending on the operating system, the installation procedure may differ. Follow carefully the setup program instructions. During driver installation, some "Found New Hardware Wizard" windows may appear: do not pay attention to them, they will disappear at the end of installation. 7. Reboot your system as asked by the installer. 8. Check the installation: a. Connect a camera to the board. b. Run MultiCam Studio and start an acquisition sequence. Refer to the documentation and release notes for more information. Please check our website to get the latest available version of MultiCam : http://www.euresys.com (*) Under Microsoft Windows 2000 operating systems, you might get the following error message at first installation : "Error 1719. The Windows Installer Service Could Not Be Accessed". This happens while upgrading Microsoft Installer to version 3.1. In this case, just click on "OK" to start the MultiCam installer again : this problem will no longer occur in subsequent MultiCam installations.